Old Mechanical Meters vs AMI / Smart Meters

How smart meter technology affects billing accuracy and audit methodology.

Subscribe to post

Thread Replies Last Post

Smart meter data access — state-by-state differences by Wendell T. helper — 6 years ago

5 years ago
by Rosa M.

PPL smart meter time-of-use rates vs old flat rate by Nick C. — 7 years ago

5 years ago
by Randy Dawson

TOU window shifted — TECO Energy didn''t notify by Mike S. — 6 years ago

6 years ago
by Bill T.

Smart meter 'estimated' readings - worse than mechanical meter estimates? by George P. — 7 years ago

7 years ago
by Helen K.

CPS Energy AMI rollout going smoothly - what are they doing right? by Angela R. — 8 years ago

8 years ago
by Marcus J.

Duke Energy AMI causing more problems than it solves? by Derek O. top — 8 years ago

8 years ago
by Phil G.

Old Westinghouse meters vs new Aclara - accuracy comparison by Gloria S. — 8 years ago

8 years ago
by Stuart A.

Chugach Electric smart meters can't handle Alaska cold by Patty L. — 8 years ago

8 years ago
by Diane O.

Smart meter interval data analysis - best software tools? by Kevin W. — 9 years ago

8 years ago
by Don S.

AMI interval data showing impossible demand spikes - software glitch? by Gary T. — 9 years ago

9 years ago
by Marcus J.

Mechanical meter final reads vs AMI start reads - huge discrepancies by Sylvia D. — 9 years ago

9 years ago
by Derek H.

Georgia Power AMI implementation disaster - anyone else experiencing this? by Greg L. — 10 years ago

9 years ago
by Pete M.

Kentucky Power mechanical meter was under-registering for years by Mike S. — 10 years ago

10 years ago
by Randy Dawson

Reactive demand vs power factor penalty — which applies? by Norm R. — 10 years ago

10 years ago
by Mike

Three-phase balancing issue at San Diego client by Connie A. — 10 years ago

10 years ago
by Ed T.

Smart meter interval data - blessing or curse for auditors? by Pete T. — 11 years ago

10 years ago
by Gloria S.

Peak demand coincident vs non-coincident — Georgia Power by Diane — 11 years ago

11 years ago
by Ken G.

Smart meter interval data - blessing or curse for audits? by Scott H. — 11 years ago

11 years ago
by Christine L.

Mechanical meter fraud vs smart meter hacking - which is worse? by Eleanor W. — 11 years ago

11 years ago
by Chuck B.

AMI meter reading intervals - how often is too often for billing disputes? by Cecilia K. — 11 years ago

11 years ago
by Chuck B.

Duke Energy smart meter readings 40% higher than old mechanical - has anyone else seen this? by Cecilia K. — 11 years ago

11 years ago
by Albert M.

Duke Energy AMI interval data shows demand spikes that don't exist by Meredith C. — 12 years ago

11 years ago
by Kim S.

Question about interval data retention with smart meters by Amir C. — 11 years ago

11 years ago
by Kim S.

Mechanical meter "creep" - how much variance is acceptable? by Albert M. — 12 years ago

12 years ago
by Elmer R.

Transformer losses — primary vs secondary metering by Meredith C. — 12 years ago

12 years ago
by Ray L.

Three-phase balancing issue at El Paso client by Juan C. — 12 years ago

12 years ago
by Darrell S.

CEI smart meter rollout - billing errors through the roof by Frank E. — 12 years ago

12 years ago
by Phil N.

Question about meter accuracy tolerance standards by Vivian C. — 12 years ago

12 years ago
by Greg L.

Old Sangamo mechanical meter still more accurate than new smart meter? by Jim W. veteran — 13 years ago

13 years ago
by Derek H.

ComEd smart meters reading 15% higher than old mechanicals - anyone else seeing this? by Yuri P. — 13 years ago

13 years ago
by Greg L.

1 2 3